Rising Bollards vs Fixed Bollards: Which Fits Your Site?
Fixed bollards are cheaper and simpler; rising bollards allow authorised vehicles through. A side-by-side comparison of cost, speed, control and maintenance.
Use fixed bollards when the lane never needs to open to vehicles. Use rising bollards when the same lane must admit authorised vehicles and block unauthorised ones. Everything else is a detail.
The core difference
A fixed bollard is a permanent obstacle. It cannot be lowered, so the lane behind it is closed to all vehicles at all times. A rising bollard retracts into the ground when a command is given and rises again after the vehicle passes, so the same lane serves both purposes.
Comparison
| Factor | Fixed bollard | Rising bollard |
|---|---|---|
| Cost per unit | Low | Significantly higher |
| Installation | Surface anchor or shallow foundation | Requires drainage and a foundation pit |
| Vehicle access | None — lane permanently closed | Controlled by remote, card, loop or ANPR |
| Rising time | Not applicable | Typically 3 to 5 seconds |
| Power failure | No impact | Needs manual release or battery backup |
| Maintenance | Visual inspection, occasional repaint | Hydraulic or electro-mechanical service, pit drainage |
| Best use | Pedestrian zones, plaza edges, permanent perimeter | Embassies, government compounds, data centres, VIP lanes |
When fixed bollards are the right answer
Pedestrian plazas, building forecourts and permanent perimeter lines do not need to open. Fixed bollards cost a fraction of rising units, need no power and cannot fail in a power cut. For a perimeter that must be permanently closed, adding rising units only adds cost and maintenance.
When rising bollards are the right answer
Rising bollards make sense where the same lane serves two conflicting purposes: a service yard that receives deliveries during the day but must be closed at night, or an entrance that admits staff vehicles but blocks a vehicle-borne attack. In those cases a barrier gate is not enough — a gate arm can be driven through, a bollard cannot.
If the requirement is anti-ram protection, confirm the impact rating the project specifies. Impact ratings are certified by test, and a supplier without test documentation cannot substantiate a rating.
Sizing the lane
Bollard diameter and spacing determine whether a vehicle can pass between units. A common arrangement for a 3.5 m lane is two to three units with a clear gap narrower than a car body. The layout should be confirmed against the site plan, not chosen from a catalogue.
Installation points that cause failures
- Drainage — the pit collects water. Without a drain or pump, the mechanism corrodes and the unit jams.
- Foundation depth — a shallow pit tilts under load and the bollard binds.
- Power and signal routing — plan cable ducts before pouring concrete, not after.
- Manual release access — the release must be reachable during a power failure without lifting a cover plate.
Frequently asked
Can rising bollards be added later to a fixed installation?
Only if the foundation was designed for it. Retrofitting requires breaking out the surface and pouring a pit, which usually means closing the lane for several days.
How fast can a rising bollard be lowered in an emergency?
Lowering time is similar to rising time. For emergency egress, confirm the control system supports a fire-alarm input that lowers the units automatically.
Need a quotation or technical support?
Send us your project details — required capacity, site conditions and target market — and we will reply within one working day.
Send an Inquiry
+86 189 2854 5264