How to Choose a Barrier Gate for Your Parking Facility

Arm length, opening time, motor type and duty cycle decide whether a barrier gate survives a site. A practical selection guide with a comparison table.

How to Choose a Barrier Gate for Your Parking Facility

Choose a barrier gate by matching three numbers to the site: the passage width, the number of vehicles per hour, and whether the lane is attended. Get those three right and the rest of the specification follows.

1. Arm length follows the passage width

Measure the clear opening between posts, not the road width. A 3 m arm covers a single lane comfortably. Between 4 and 4.5 m, a straight arm starts to flex and the gate needs a heavier spring setting. Beyond 4.5 m, use a folding arm or a fence arm rather than a longer straight arm — a long straight arm sags, and the motor works harder on every cycle.

If the lane carries wind exposure (coastal sites, open compounds), reduce the arm length or specify a fence arm with a smaller sail area.

2. Opening time follows the traffic volume

Opening time is the interval from command to fully open. A gate rated at 0.9 s suits high-frequency toll or car park exit lanes. A gate rated at 3 to 6 s suits residential entrances and sites where vehicles arrive one at a time.

Faster is not automatically better. A very fast gate on a low-traffic site costs more and exposes pedestrians to a faster-moving arm. Match the speed to the lane, and always specify a loop detector or photocell so the arm cannot close on a vehicle.

3. Motor type follows the duty cycle

Motor type Typical duty Best for
AC motor with limit switches Low to medium Residential entrances, low-traffic industrial gates
DC brushless Medium to high Commercial car parks, mixed-use sites
Servo / high-frequency High Toll lanes, 24-hour exit lanes

Duty cycle is the share of time the motor runs and rests. A gate rated for continuous operation on a toll lane will fail quickly on a residential entrance, and a residential-grade gate will overheat on a toll lane. Ask for the rated cycles per hour and compare it to your peak hour.

4. Protection grade follows the environment

IP54 is adequate for a covered car park entrance. For an open compound exposed to rain and dust, specify IP65 or above. Coastal sites need a corrosion-resistant housing finish; standard powder coating on cold-rolled steel will show rust within a season if the salt spray reaches the housing.

5. What to specify alongside the gate

  • Loop detector — prevents the arm closing on a vehicle that has not cleared
  • Photocell or radar — second layer of protection for pedestrians
  • Manual release — required so the lane can be opened during a power failure
  • Control interface — confirm whether the site uses dry contact, Wiegand, RS485 or a network API

Common mistakes

Ordering by arm length alone is the most frequent error. A 6 m arm on a 90 W motor opens slowly, sags and burns out the motor within a year. The second most frequent error is ignoring wind load: a fence arm on an exposed site acts as a sail and the gate stalls mid-cycle.

If the lane is unattended and integrated with ticket machines or ANPR cameras, confirm the control board supports the signals your system produces before ordering. Retrofitting an interface after installation often means replacing the control board.

Frequently asked

Can one barrier gate serve two lanes?

Only if both lanes merge before the gate and the merge point is controlled. Two parallel lanes need two gates.

How often does a barrier gate need servicing?

For a commercial car park, inspect the spring balance, arm pivot and limit switches every six months. High-frequency toll lanes need quarterly checks.

Need a quotation or technical support?

Send us your project details — required capacity, site conditions and target market — and we will reply within one working day.

Send an Inquiry